Robert Axle Project thru axles allow modern frames to be used with axle mount trainers.
- For use with bike trainers such as 1up, Blackburn, Cyclops, Kinetic, Tacx and more
- IMPORTANT: Before ordering, make sure your specific trainer will accommodate the width of the thru-axle equipped bike that you are using
- Measure trainer at the widest setting and measure the bike frame width at the rear hub
- The Robert Axle ends will extend 15mm past the frame on each side
- Axle shaft and axle ends are machined from 7075 aluminum and hard anodized
- Installed or removed using a 5mm Allen wrench
- Designed, built and tested in the USA
Description
Robert Axle Project thru axles allow modern frames to be used with axle mount trainers.
- For use with bike trainers such as 1up, Blackburn, Cyclops, Kinetic, Tacx and more
- IMPORTANT: Before ordering, make sure your specific trainer will accommodate the width of the thru-axle equipped bike that you are using
- Measure trainer at the widest setting and measure the bike frame width at the rear hub
- The Robert Axle ends will extend 15mm past the frame on each side
- Axle shaft and axle ends are machined from 7075 aluminum and hard anodized
- Installed or removed using a 5mm Allen wrench
- Designed, built and tested in the USA
- Choosing a selection results in a full page refresh.
- Press the space key then arrow keys to make a selection.