The Conversion kit allows you to easily swap your power sensor to new pedal bodies for use on another bike. This kit contains all the components you need to make the switch.Intended for Rally RK se...
The Conversion kit allows you to easily swap your power sensor to new pedal bodies for use on another bike. This kit contains all the components you need to make the switch.Intended for Rally RS se...
Spindle and Bearing Assemblies for repairing or servicing LOOK pedals.
For LOOK X-Track pedals, amd fully rebuildable with the X-Track spindle kit
The kit includes: fresh spindles, bearings, bushin...
The Conversion kit allows you to easily swap your power sensor to new pedal bodies for use on another bike. This kit contains all the components you need to make the switch.Intended for Rally XC se...
The Cleat Screw Kit is a bike fitter's best friend because it eliminates the difficulty (and in some cases impossibility) of finding the perfect type and length of cleat screw.
The Kit contains 150...
Keo Pedal Blade Kits
Compatible with the KEO BLAD
Includes - 2 blades (springs) 2 pins and 2 retention clips
Material - Composite springE (non carbon) pedals, the composite blade kit allows you to ...
These pedal pins come in two sizes and the longer pins can be used one of two ways for customizing grip.
16 short pins (8.5mm overall length) for pedal's center section
28 long pins (12.5mm overall...
Vision light kits are the solution to take your Look pedals into the night. Ride with increased safety and visibility in traffic when the sun goes down thanks to the 3 different flash modes, an aut...
Freshen up your pedals with new end caps that provide a proper seal for the spindle and bearings.
Fits X-Track Pedals
Includes Two plugs and Removal/installation tool
These pedal pins come in two sizes and the longer pins can be used one of two ways for customizing grip.
16 short pins (8.5mm overall length) for pedal's center section
28 long pins (12.5mm overall...
Spindles are each 5mm longer than Crank Brother's standard spindles to provide a wider Q-factor.
Compatible with 2010 - present Egg Beater, Candy, Mallet, 5050 and Double Shot pedals
Includes 2 lon...
Cleat screws are intended for proper installation of the Cleat Wedge. Designed to withstand high torque levels, creating a secure and reliable connection between the rider and the bike. Available i...
Part kits needed to service DMR pedal internals.
2 sealed bearings
2 bushings
Regular and reverse threaded nuts (one each)
2 end caps
2 washers
For use with DMR Vault pedals only
The titanium spindle kit lowers the weight of any Crank Brothers pedal by 30+ grams. 200 pound rider weight limit.
Compatible with 2010 - present Egg Beater, Candy, Mallet, 5050 and Double Shot ped...
Keo Pedal Blade Kits
Designed for KEO Blade Carbon Pedals
Compatible models: classic, ceramic and Ti surface
Retension 12 for standard use
Includes - 2 blades (springs) 2 pins and 2 retention clip...
